Vantec UGT-ST310R User Guide - Page 17

For An Existing Installation 1. Setup the RAID Array prior to driver installation and boot up to Windows. 2. At the Found New Hardware Wizard, select No, not this time, then click Next. 3. Insert the driver CD, select Install the software automatically (Recommended), and click Next. 4. Click Finish. 5. Restart Windows to complete the driver installation. For Windows® XP-x64/Server 2003-x64 For A New Installation A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the "UGT-ST310R\XP_2003_Vista\64bit" folder, found on the driver CD, onto a blank floppy disk then follow the directions below. 1. Setup the RAID Array prior to Windows installation. 2. Follow Microsoft's Windows installation procedure. 3. At the Windows Setup screen, press F6 to install the RAID driver. 4. When prompted, press S to specify the location of the driver. 5. Insert the floppy disk, then press Enter. 6. Select Silicon Image SiI 3114 SoftRAID 5 Controller (64- bit Extended), then press Enter. 7. Press Enter to finish driver installation, then follow the on- screen instructions to complete the Windows installation. For An Existing Installation UGT-ST310R Page 17