Vtech DS6251-2 User Manual - Page 17

Install the battery Install the battery as shown below. • Use only supplied battery. • Charge the battery provided with this product only in accordance with the instructions and limitations specified in this manual. • If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage. THIS SIDE UP Charge the battery Place the handset in the telephone base or the charger to charge. Once you have installed the battery, the handset LCD display indicates the battery status (see the table below). • For best performance, keep the handset in the telephone base or charger when not in use. • The battery is fully charged after 12 hours of continuous charging. • If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays No battery. Battery Battery Action indicators status The screen The battery Charge without is blank, or has no or very interruption displays Place little charge. (at least 30 in charger and The handset minutes). flashes. cannot be used. The screen displays Low battery and flashes. The screen displays HANDSET X. The battery has enough charge to be used for a short time. The battery is charged. Charge without interruption (about 30 minutes). To keep the battery charged, place it in the telephone base or charger when not in use. When the battery is fully charged, you can expect the following performance: Operation While in use (talking*) While in speakerphone mode (talking*) While not in use (standby**) Operating time Seven hours Three and a half hours Five days * Operating times vary depending on your actual use and the age of the battery. ** Handset is not charging nor in use. 9