Weider 350 Bench English Manual - Page 14

25. Route the Lat Cable (74) under a 90mm Pulley 25 (55). Attach the Pulley and a Cable Trap (61) to two Pulley Plates (59) with an M10 x 48mm Bolt (92), two Half Guards (58), and an M10 Nylon Locknut (80). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. Do not overtighten the Nylon Locknut; the Pulley must turn freely. 26. Route the Lat Cable (74) up through the Top 26 Frame (31), over a 90mm Pulley (55), and down through the Top Frame. Next, attach the Pulley inside the Top Frame with an M10 x 68mm Bolt (85), two M10 Washers (83), two 16mm x 13mm Spacers (77), and an M10 Nylon Locknut (80). 80 61 58 59 74 55 58 92 59 55 80 83 77 74 31 77 83 85 27. Attach the Lat Cable (74) to the Weight 27 Carriage (35) with the M10 x 20mm Bolt (89) and an M10 Nylon Locknut (80). 74 80 89 35 28. Identify the Butterfly Cable (76). Attach the 28 Cable to the Left Butterfly Arm (33) with an M8 x 22mm Shoulder Bolt (101) and an M8 Nylon Locknut (81). Make sure the flat edge of the Cable is against the Butterfly Arm. Do not overtighten the Nylon Locknut; the Cable must pivot freely. Flat Edge 14 101 76 33 81