Weider 350 Bench English Manual - Page 15

29. Wrap the Butterfly Cable (76) around a "V"-pul- 29 ley (56). Attach the "V"-pulley and a Large Cable Trap (63) to the Center Upright (26) with an M10 x 62mm Bolt (88), two Guards (62), an M10 Washer (83), and an M10 Nylon Locknut (80). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. Do not overtighten the Nylon Locknut; the Pulley must turn freely. 80 83 76 26 63 62 88 62 56 30. Route the Butterfly Cable (76) under a 90mm 30 Pulley (55). Attach the Pulley to the Double Pulley Bracket (60) with an M10 x 48mm Bolt (92), two Half Guards (58), and an M10 Nylon Locknut (80). Do not overtighten the Nylon Locknut; the Pulley must turn freely. 76 58 80 55 92 58 60 31. Route the Butterfly Cable (76) over a "V"-pulley 31 (56). Attach the "V"-pulley and a Large Cable Trap (63) to the Center Upright (26) with an M10 x 62mm Bolt (88), two Guards (62), an M10 Washer (83), and an M10 Nylon Locknut (80). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. Do not overtighten the Nylon Locknut; the Pulley must turn freely. 32. Attach the Butterfly Cable (76) to the Right 32 Butterfly Arm (34) with an M8 x 22mm Shoulder Bolt (101) and an M8 Nylon Locknut (81). Make sure the flat edge of the Cable is against the Butterfly Arm. Do not overtighten the Nylon Locknut; the Cable must pivot freely. 15 88 62 63 56 76 83 62 80 26 101 76 34 81 Flat Edge