Weider 350 Bench English Manual - Page 6
Assembly
View all Weider 350 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Make Assembly Easier Everything in this manual is designed to ensure that the weight bench can be assembled successfully by almost anyone. By setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • To hire an authorized service technician to assemble the weight bench, call 1-800-445-2480. • Assembly requires two persons. • Because of its size, the weight bench should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the weight bench as you assemble it. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Tighten all parts as you assemble them, unless instructed to do otherwise. • Assembly requires the included hex key(s) and the following tools (not included): two adjustable wrenches one rubber mallet one standard screwdriver one Phillips screwdriver Assembly may be more convenient if you have a socket set, a set of open-end or closed-end wrenches, or a set of ratchet wrenches. 1. Before beginning assembly, make sure 1 you understand the information in the box above. Orient the Bench Rear Stabilizer (2) so that the warning decal is in the position shown. Attach the Bench Rear Stabilizer to the Bench Frame (1) with two M10 x 62mm Carriage Bolts (97) and two M10 Nylon Locknuts (80). Do not tighten the Nylon Locknuts yet. 2. Attach the Front Leg (3) to the Bench Front 2 Stabilizer (5) with two M10 x 68mm Bolts (85), four M10 Washers (83), and two M10 Nylon Locknuts (80). Do not tighten the Nylon Locknuts yet. Attach the Front Leg (3) to the Bench Frame (1) with two M10 x 68mm Bolts (85), four M10 Washers (83), and two M10 Nylon Locknuts (80). Do not tighten the Nylon Locknuts yet. 80 1 2 Warning Decal 97 1 80 83 3 83 80 83 83 85 83 85 83 5 6