Weider 350 Bench English Manual - Page 16

33. Identify the Low Cable (75). Route the Cable through the Center Upright (26) and under a 115mm Pulley (57). Attach the Pulley inside the Upright with an M10 x 68mm Bolt (85), two M10 Washers (83), two 16mm x 13mm Bushings (77), and an M10 Nylon Locknut (80). 33 83 80 77 26 75 57 77 83 85 34. Route the Low Cable (75) over a 90mm Pulley 34 (55). Attach the Pulley to the Double Pulley Bracket (60) with an M10 x 48mm Bolt (92), two Half Guards (58), and an M10 Nylon Locknut (80). Do not overtighten the Nylon Locknut; the Pulley must turn freely. 92 58 60 55 58 80 75 35. Route the Low Cable (75) under a 90mm Pulley (55). Attach the Pulley to the Rear Base (25) 35 with an M10 x 48mm Bolt (92), two Half Guards (58), and an M10 Nylon Locknut (80). Do not overtighten the Nylon Locknut; the Pulley must turn freely. 58 80 55 75 36. Route the Low Cable (75) over a 90mm Pulley 36 (55). Attach the Pulley and a Cable Trap (61) to the two Pulley Plates (59) with an M10 x 48mm Bolt (92), two Half Guards (58), and an M10 Nylon Locknut (80). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. Do not overtighten the Nylon Locknut; the Pulley must turn freely. 58 92 25 80 58 61 55 59 58 92 75 16