Weider Club 4870 English Manual - Page 18
Make sure the Half Guards
View all Weider Club 4870 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
35. Attach a Pulley (43) inside the Curl Post Upright 35 (10), above the Low Cable (70), with an M10 x 65mm Bolt (87), two M10 Washers (108), two 1/2" Bushings (68), and an M10 Nylon Locknut (84). 68 84 108 10 43 70 68 108 87 36. Route the Low Cable (70) through the Right Seat 36 Upright (11) and the Right Upright (7) and under a Pulley (43). Attach the Pulley, an M10 Washer (108), and two Half Guards (46) to the Right Base (1) with an M10 x 45mm Bolt (95) and an M10 Nylon Locknut (84). Make sure the Half Guards are oriented as shown. 37. Wrap the Low Cable (70) over a Pulley (43). 37 Attach the Pulley, a Cable Trap (48), and two Half Guards (46) at the second hole from the bottom of the two Pulley Plates (49) with an M10 x 50mm Bolt (105) and an M10 Nylon Locknut (84). Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. Make sure the Half Guards are oriented as shown. 7 84 46 108 70 43 11 46 1 95 84 46 48 43 49 46 105 70 18