Weider Pro 4250 English Manual - Page 14
Attach the V-pulley, two Half Finger Guards - cable
View all Weider Pro 4250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
27. Wrap the Press Cable (109) around a "V"-pulley (62). Attach the "V"-pulley, two Half Finger Guards (66), a Large Cable Trap (111), and an M10 Washer (99) inside the bracket on the Left Upright (26) with an M10 x 65mm Bolt (77) and an M10 Nylon Locknut (90). Make sure the Cable Trap and Finger Guards are oriented as shown. 27 77 26 90 66 99 62 109 111 66 28. Wrap the Press Cable (109) around a 90mm Pulley (63). Attach the Pulley, two Half Finger Guards (66), a Cable Trap (68), and an M10 Washer (99) to the Press Frame (29) with the M10 x 134mm Bolt (70) used in step 26 and an M10 Nylon Locknut (90). Make sure the Cable Trap and Finger Guards are oriented as shown. 28 66 90 63 109 99 68 66 29 70 29. Wrap the Press Cable (109) under a 90mm 29 Pulley (63). Attach the Pulley, two M10 Washers (99), and two Half Finger Guards (66) inside the bracket on the Left Base (25) with an M10 x 48mm Bolt (64) and an M10 Nylon Locknut (90). Make sure the Finger Guards are oriented as shown. 99 66 90 66 63 99 64 109 25 30. Wrap the Press Cable (109) over a 90mm Pulley 30 (63). Attach the Pulley and a Cable Trap (68) to the Right Top Frame (5) with an M10 x 43mm Bolt (80) and an M10 Nylon Locknut (90). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 80 68 63 5 90 109 14