Weider Pro 4250 English Manual - Page 22
the Short Pad Tube 35. - parts
View all Weider Pro 4250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
61. Attach the Lock Plate (21) to the Right Seat 61 Frame (3) with an M8 x 67mm Shoulder Bolt (41), an M8 Washer (98), and an M8 Nylon Locknut (91). Do not overtighten the Locknut; the Lock Plate must be able to pivot easily. 91 98 3 Attach the Leg Pin (24) to the Right Seat Frame (3) with an M4 x 16mm Self-tapping Screw (89). Insert the Leg Pin through the Leg Lever (4) and the Lock Plate (21). 89 24 4 21 41 62. Insert the Long Pad Tube (16) into the Right Seat 62 Frame (3). Slide two Small Foam Pads (18) onto the Pad Tube. Press two Foam Caps (17) into the Pad Tube. 17 18 Repeat this step with the Leg Lever (4) and the Short Pad Tube (35). 3 16 4 35 18 17 63. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in ADJUSTMENTS, beginning on the following page. Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE DIAGRAMS on pages 26 and 27 of this manual for proper cable routing. If there is any slack in the cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 28. 22