Weider Pro 4250 English Manual - Page 17
Frame 5. Attach the Pulley inside the Top Frame - weight
View all Weider Pro 4250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
41. Route the Weight Cable (110) over a 90mm 41 Pulley (63) and down through the Right Top Frame (5). Attach the Pulley inside the Top Frame with an M10 x 80mm Bolt (75), two M10 Washers (99), two M10 x 19mm Spacers (102), and an M10 Nylon Locknut (90). 75 99 102 99 90 63 110 5 42. Wrap the Weight Cable (110) under a 90mm 42 Pulley (63). Attach the Pulley, a Cable Trap (68), and two Half Finger Guards (66) at the second hole from the top of the two Pulley Plates (51) with an M10 x 48mm Bolt (64) and an M10 Nylon Locknut (90). Make sure the Cable Trap and Finger Guards are oriented as shown. 43. Wrap the Weight Cable (110) over a 90mm Pulley (63). Attach the Pulley to the indicated bracket on 43 the Right Top Frame (5) with an M10 x 43mm Bolt (80) and an M10 Nylon Locknut (90). Bracket 5 110 64 63 66 66 90 68 51 51 90 44. Wrap the Weight Cable (110) over a 90mm Pulley (63). Attach the Pulley and a Cable Trap (68) to the indicated bracket on the Right Top Frame (5) with an M10 x 43mm Bolt (80) and an M10 Nylon Locknut (90). Make sure the Cable Trap is oriented to hold the Cable in the groove of the Pulley. 44 Attach pulley on this side 45. Set the M12 Washer (33) on top of the Weight 45 Tube (47). Thread the M12 Nut (49) all the way onto the Weight Cable (110). Thread the Weight Cable (110) into the Weight Tube (47) a couple of turns. 80 63 110 Bracket 80 5 63 68 110 90 110 49 33 47 17