Xerox 1235N Service Guide - Page 11

Removing the entrance sensor board 113 Removing the high voltage power supply 115 Removing the low voltage power supply 116 Removing the control panel 117 Removing the feed roller and nudger roller 118 Removing the retard pad 119 Removing the paper size sensing board 121 Removing the paper size sensing actuator 122 Removing the main feeder assembly 124 Removing the lower plate assembly 125 Removing the paper tray lift arm roller 126 Removing the multi-sheet bypass feeder 128 Removing the multi-sheet bypass feeder entrance sensor actuator 129 Removing the tray 1 entrance sensor actuator 130 Removing the belt entrance sensor actuator 131 Removing the transfer belt unit 132 Removing the registration clutch 133 Removing the registration motor assembly 134 Removing the registration roller assembly A and drive gear 136 Removing the registration roller assembly B 138 Removing the fuser unit 139 Fuser latching handle (left) 140 Removing the fuser latching handle (right) 141 Removing the fuser exit roller 143 Removing the exit sensor assembly 145 Removing the duplex guide assembly 147 Removing the eject guide assembly 148 Removing the LED Assembly power connector 149 Removing the stack full sensor 150 Removing the main motor assembly 152 Removing the main feeder drive motor 153 Removing the transfer belt motor assembly 155 Removing the shutter plate 156 Removing the color registration sensor assembly 157 Removing the color registration solenoid 158 Removing an LED assembly 159 Removing the drum contact assembly 160 Disconnecting the LED assembly power harness 161 Removing the toner sensor actuators 162 Removing the duplex unit 163 Removing the feeder control board cover 164 Removing the idler roller assembly 165 Removing the optional feeder inner frame bottom screws 166 Service Guide xi