Xerox 1235N Service Guide - Page 145
Belt entrance sensor actuator, Removing the belt entrance sensor actuator
![]() |
UPC - 042215474580
View all Xerox 1235N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 145 highlights
Belt entrance sensor actuator Warning Switch off the power and disconnect the power cord. 1. Remove the printer unit chassis described in the topic "Printer unit chassis (and low-voltage power supply fan)" on page 97. 2. Remove the Tray 1 entrance sensor actuator as described in the topic "Tray 1 entrance sensor actuator" on page 130. 3. Remove the entrance sensor board as described in the topic "Entrance sensor board" on page 113. 4. From the bottom, squeeze the two locking tabs securing the belt entrance sensor actuator. 5. Remove the actuator from the top. Removing the belt entrance sensor actuator Reverse these steps to install the belt entrance actuator. For reassembly, install the entrance sensor actuator and ensure the spring arm is properly located in the notch in the printer unit chassis. Service Guide 131
![](/manual_guide/products/xerox-1235n-service-guide-00d220f/145.png)