Xerox 750DP 5750 Administrator Guide - Page 32
Setup, Printer Setup, PS Setup, Color Setup, and then Job Log Setup. - review
![]() |
UPC - 042215455107
View all Xerox 750DP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
22-4 Setting up the DocuColor For software update or setup, press any key. 4. At the startup message, press any button. The Start Up screen is displayed. Run Setup Install Software Format Disk Start Up Exit Setup Server Setup Network Setup Printer Setup Setup PS Setup Color Setup Job Log Setup Calibration Setup Change Password Clear Server Setup 5. Choose Run Setup to access all setup menus. The Install Software and Format Disk commands are for service technicians. 6. Press the line selection button to choose a Setup menu or command. Press the down arrow to view the second and third screens of the main Setup menu. 7. Choose setups in the same order as they appear in the menu: Server Setup, Network Setup, Printer Setup, PS Setup, Color Setup, and then Job Log Setup. The sequence is important for first-time Setup. Later, just go directly to the menu you want to change. However, if you make changes in Network Setup, you may need to change some settings in Printer Setup as well. NOTE: If you make changes in Server, Network, or Printer Setup, you'll need to update the system configuration by opening and saving the other Setups even if you haven't changed any other settings. TO ACCESS SETUP WHEN THE DOCUCOLOR IS OFF: 1. Make sure the DocuColor is connected to the copier and connected to the network you will use. 2. Turn on the DocuColor. The startup diagnostics are performed. 3. At the startup message, press any button. 4. Continue with step 5 from the previous procedure. Review the settings described in this chapter. For more information on calibration, and on Control Panel screens other than those in Setup, see the User Guide.
![](/manual_guide/products/xerox-750dp-5750-administrator-guide-82b86bd/32.png)