Yamaha AP-U70 Owner's Manual - Page 4

GETTING STARTED Unpacking Battery installation After unpacking, check that the following items are supplied. ● Remote control POWER ● Batteries (AA, R6, UM-3 type) USB PC AUX1 AUX2 HALL JAZZ CHURCH GAME MOVIE LIVE VDD TEST ON/OFF A B C ● USB cable MUTE VOLUME ● CD-ROM The CD-ROM contains the Application Software and online help for controlling this unit from your computer. Since the remote control will be used for many of this unit's control operations, you should begin by installing the supplied batteries. 1 3 2 1 Turn the remote control over and remove the battery compartment cover by sliding it in the direction of the arrow. 2 Insert the batteries (AA, R6, UM-3 type) according to the polarity markings on the inside of the battery compartment. 3 Close the battery compartment cover. Battery replacement If you notice that the remote control must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones. Notes ● Use AA, R6, UM-3 batteries. ● Be sure the polarities are correct. (See the illustration inside the battery compartment.) ● Remove the batteries if the remote control is not to be used for an extended period of time. ● If the batteries leak, dispose of them immediately. Avoid touching the leaked material and avoid contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. Remote control operation range USB PC AUX1 AUX2 VIRTUAL 5.ICH DIGITAL USB PCM D. DSP PROLOGIC FM AM ST VOL DSP MUTE Remote control sensor Within approximately 6 m (19.7 feet) 30° 30° Notes ● The area between the remote control and the main unit must be clear of large obstacles. ● Do not expose the remote control sensor to strong lighting, in particular, an inverter type fluorescent lamp; otherwise, the remote control may not work properly. If necessary, position the main unit away from direct lighting. E-2