Yamaha DGX-305 Owner's Manual - Page 86

Reference Accessory CD-ROM Installation Guide Installing the driver on Windows 98/Me 1 Start the computer. 2 Insert the supplied CD-ROM into the CD- ROM drive. A start window will appear automatically. Close the window. 3 First, make sure the POWER switch on the instrument is set to OFF, then use a USB cable to connect the USB terminal of the computer to the USB connector of the instrument. When the instrument is turned on, the computer automatically displays the "Add New Hardware Wizard." If the Add New Hardware Wizard does not appear, click "Add New Hardware" in the Control Panel. For Windows Me users, check the radio button to the left of "Automatic search for a better driver (Recommended)" and click [Next]. The system automatically starts searching and installing the driver. Proceed to Step 8. If the system does not detect the driver, select "Specify the location of the driver (Advanced)" and specify the CD-ROM drive's "USBdrv_" folder to install the driver and click [Next]. Execute the installation by following the onscreen instructions and proceed to Step 8. NOTE • If you are using Windows Me, skip Step 4 - 7. 4 Click [Next]. The window enables you to select the search method. 5 Check the radio button to the left of "Search for the best driver for your device. (Recommended)." Click [Next]. The window enables you to select a location in which to install the driver. 6 Check the "Specify a location" box, click "Browse..", then specify the USBdrv directory of the CD-ROM drive (such as D:\USBdrv_\) and continue the installation. 7 When the system detects the driver on the CD-ROM and is ready for installation, it is shown as a message on the screen. Make sure that the "YAMAHA USB MIDI Driver" is listed, and click [Next]. The system starts the installation. 8 When installation is complete, a message indicating so appears. Click [Finish]. NOTE • Some computers may take about ten seconds to show this screen after the installation is complete. The driver has been installed. 86 DGX-505/305 Owner's Manual Installing the driver on Windows 2000 1 Start the computer and use the "Administra- tor" account to log into Windows 2000. 2 Select [My Computer] ➔ [Control Panel] ➔ [System] ➔ [Hardware] ➔ [Driver Signing] ➔ [File Signature Verification], and check the radio button to the left of "Ignore - Install all files, regardless of file signature" and click [OK]. 3 Insert the supplied CD-ROM into the CD- ROM drive. A start window will appear automatically. Close the window. 4 First, make sure the POWER switch on the instrument is set to OFF, then use a USB cable to connect the USB connector of the computer to the USB connector of the instrument. When the instrument is turned on, the computer automatically displays the "Found New Hardware Wizard." Click [Next]. 5 Check the radio button to the left of "Search for a suitable driver for my device. (Recommended)." Click [Next]. The window that appears enables you to select a location in which to install the driver. 6 Check the "CD-ROM drives" box and uncheck all other items. Click [Next]. NOTE • The system may ask you to insert a Windows CD-ROM while it checks for the driver. Specify the "USBdrv2k_" directory of the CDROM drive (such as D:\USBdrv2k_\) and continue the installation. 7 When the installation is complete, the sys- tem displays "Completing the Found New Hardware Wizard." Click [Finish]. NOTE • Some computers may take about ten seconds to show this screen after the installation is complete. 8 Restart the computer. The driver has been installed.