Yamaha DGX-640 Owner's Manual - Page 12
Post-assembly checklist, Put the keyboard on the stand.
View all Yamaha DGX-640 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Setting Up Setting Up 4 At least 10 cm Be sure to place your hands at least 10 cm from either end of the keyboard when positioning it. At least 10 cm 4 Put the keyboard on the stand. Check the back-to-front orientation for stand, and carefully place the keyboard on the side boards. Slowly move the keyboard so that the holes on the bottom of the keyboard are properly aligned with the holes on the angle brackets. CAUTION • Be careful not to drop the keyboard or to get your fingers caught between the keyboard and the stand parts. • Do not hold the keyboard in any position other than the position shown in the illustration. 5 r 5 x 16 mm roundhead screws 12 Owner's Manual 5 Install the keyboard to the stand. Fix the keyboard to the angle brackets, using the screws r. Post-assembly checklist Once you've assembled the stand, check the following points: • Are there any parts left over? If so, read the assembly instructions again and correct any errors you might have made. • Is the instrument clear of doors and other movable fixtures? If not, move the instrument to an appropriate location. • Does the instrument make a rattling noise when you play it or move it? If so, properly tighten all screws. • Also, if the keyboard makes a creaking noise or seems unsteady when you play it, refer carefully to the assembly instructions and diagrams and retighten all screws.