Yamaha DVX-700 Owner's Manual - Page 22
Connecting an HDMI component, Connecting the FM antenna
View all Yamaha DVX-700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
OTHER CONNECTIONS ■ Connecting an HDMI component HDMI (High-Definition Multimedia Interface) is the first industry-supported, uncompressed, all-digital A/V (audio/ video) interface. By connecting to an HDMI component (such as a TV), you can enjoy standard, enhanced or high-definition video as well as digital audio using a single cable. When used in combination with HDCP (High-bandwidth Digital Content Protection), HDMI provides a secure audio/video interface that meets the security requirements of content providers and system operators. For further information on HDMI, visit the HDMI website at "http://www.hdmi.org/". Viewing and Listening to playback from an HDMI component To output an HDMI signal, you need to configure the settings manually. It is necessary to prepare in advance to output an HDMI signal. 1 Set the system to standby mode. 2 Connect the HDMI terminals on your HDMI compatible device and the DVD controller using a commercially available HDMI cable. TV HDMI IN 4 To set the video output according to the HDMI compatible device, refer to "Video Output" on page 38 to access the DVD setup menu, and then set the two items under Video output in the system menu. - HDMI Resolution - HDMI Color Notes - This unit is designed to connect to HDMI compatible devices. If you connect to the DVI component, the system may not operate correctly. - The DVD controller is not compatible with HDCPincompatible HDMI or DVI components. - You need a commercially available HDMI/DVI conversion cable when you connect the DVD controller to other DVI components. - If you connect the system to the DVI component with a HDMI/DVI conversion cable, the HDMI terminal of the DVD controller does not output any audio signals. - Do not disconnect or connect the HDMI cable from the DVD controller or turn off the power of the HDMI/DVI component connected to the HDMI OUTPUT terminal of the DVD controller while data is being transferred. Doing so may disrupt playback or cause noise. - PCM signal downmixed to two channels can be output from the HDMI output terminal. ■ Connecting the FM antenna DVD controller VIDEO Y PB PR COMPONENT VIDEO OUTPUT HDMI OUTPUT 3 To output an audio signal from the DVD controller to the HDMI compatible device, refer to "System menu" on page 65. After doing the settings, set the DVD controller to standby mode, and then turn on the system again. ANTENNA FM 75 UNBAL. INPUT Subwoofer/system control Connect an indoor FM antenna to the ANTENNA terminal. Extend the FM antenna and fix its ends to the wall. For better FM stereo reception, connect an external FM antenna. Notes - Adjust the position of the antenna for optimal reception. - Position the antenna as far as possible from your TV, VCR or other sources of radiation to prevent unwanted interference. 18 En