Yamaha DVX-700 Owner's Manual - Page 72

TROUBLESHOOTING Problem The picture is not displayed on the TV screen. The picture is not displayed on the TV screen correctly. The message "HDMI ERROR" is displayed or the picture is not displayed on the HDMI TV screen. Cause The TV cables may be connected improperly. If the COMPONENT VIDEO OUTPUT and HDMI connections are used simultaneously, the COMPONENT VIDEO OUTPUT jacks may output progressive video signal regardless of the Component Out setting. The Video Output settings may be incorrect. The Component Out setting is set to Progressive, but the TV connected to the COMPONENT VIDEO OUTPUT may not support progressive scanning. The TV connected to the HDMI OUTPUT terminal may not support the selected resolution. The wrong HDMI resolution may be selected or an HDMI error may have occurred. Remedy Make sure all cables are connected properly. Disconnect the HDMI component, or connect a TV that supports progressive video to the COMPONENT VIDEO OUTPUT jacks. Check the Video Output settings and correct as necessary. Change the Component Out setting to Interlace. Change the HDMI Resolution setting to a resolution supported by the HDMI TV. Check the HDMI Resolution setting and correct as necessary. Reset the HDMI settings. See page 17 18 38 38 38 38 65 Tuner (FM) Problem FM stereo reception is noisy. There is distortion, and clear reception cannot be obtained, even with a good FM antenna. The desired station cannot be tuned into with the automatic tuning method. Cause The characteristics of FM stereo broadcasts may cause this problem when the transmitter is too far away, or if the antenna quality is poor. There is multi-path interference. The signal is too weak. Remedy Check the antenna connections. Try using a high-quality directional FM antenna. Use the manual tuning method. Adjust the antenna position to eliminate multi-path interference. Use a high-quality directional FM antenna. Use the manual tuning method. See page 18 -- 46 -- -- 46 XM Satellite Radio If an operation takes longer than usual or an error occurs, one of the following messages may appear in the front panel display. In this case, read the causes and follow the corresponding remedies. Status message CHECK XM TUNER Cause Remedy The XM Mini-Tuner is not installed in the XM Mini-Tuner Home Dock or the XM Mini-Tuner Home Dock is not connected to this unit. Confirm the XM Mini-Tuner is fully seated in the dock and check that the XM Mini-Tuner Home Dock cable is connected to this unit. See page 50 CHECK ANTENNA The XM antenna is not connected to Check that the XM antenna is securely 50 the XM Mini-Tuner Home Dock or the connected to the XM Mini-Tuner XM antenna cable has become Home Dock and check the antenna damaged. cable for damage. Replace the XM antenna if the cable is damaged. 68 En