Yamaha DVX-S150 Owner's Manual - Page 77
Controlling External Components, Setting remote control codes
View all Yamaha DVX-S150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
CONTROLLING EXTERNAL COMPONENTS Controlling External Components In addition to controlling this unit, you can operate your TV, VCR, CD recorder or MD recorder with the CinemaStation remote control by selecting the appropriate remote control code (refer to "LIST OF REMOTE CONTROL CODES" at the end of this manual). Note Depending on the product, the CinemaStation remote control may not be able to operate the external component. In this case, use the remote control supplied with the product. Setting remote control codes The TV button selects a remote control code for a TV. The VCR button selects a remote control code for a VCR, CD recorder, or MD recorder. STANDBY/ON POWER TV AUDIO ANGLE SUBTITLE SURROUND SELECT MATRIX 6.1 STEREO REPEAT A-B NIGHT SW CENTER SURR SET MENU TV CH PRESET TV INPUT SHIFT A B C D E SLEEP PRESET FREQ/RDS MODE PTY SEEK START ON SCREEN START MENU YPAO CH ENTER CH STATUS RETURN ON/OFF TV VOL MUTE TEST VOLUME AMP DVD/CD VCR VIDEO TUNER MOVIE MUSIC SPORTS GAME TV Number buttons SHIFT VCR CINEMA 1 While holding down SHIFT, press TV or VCR, then while still holding down SHIFT, press the number buttons to enter the three-digit remote control code (refer to "LIST OF REMOTE CONTROL CODES" at the end of this manual) for the manufacturer of your component. If the setting is successful, the message "Code Set OK" appears in the CinemaStation display. If the setting fails, the message "Code Set NG" appears. In this case, perform this step again. The factory settings are "299" (YAMAHA TV) for TV and "399" (YAMAHA VCR) for VCR. 2 Refer to "Available operations" (page 73) and try one of the button operations for your component to check that the setting is working properly. If the button operation does not work properly, the remote control code may be incorrect. In this case, perform step 1 again. Notes • Even if you set a remote control code, it will be cleared about two minutes after the remote control batteries run out. In this case, store remote control codes again after replacing the batteries. (Be careful not to press the remote control buttons while replacing the batteries. Doing so may clear the settings.) • Depending on the product, the CinemaStation remote control may not be able to operate the external component. In this case, use the remote control supplied with the product. • If the manufacturer of your component has more than one code, try each of them until you find the correct one. 72