Yamaha Dante-MY16-AUD Dante-MY16-AUD and R Series HA Remote Control Guide - Page 11

Yamaha Commercial Audio Dante-MY16-AUD HA Remote Control Guide Settings by Dante Controller When you start Dante Controller, the Network View opens first, and all the Dante equipment on the network appear. This allows you to set the audio routing between Dante devices. Click a cell in the intersection of transmit and receive channels to set an audio route from the upper-right transmit channel to the lower-left receive channel. When the route is set, a green icon appears. For details, please refer to the Dante Controller user manual. Double-click a device name of the Dante-MY16-AUD card (communicating an HA control signal with host equipment) to open the Device View window. On the HA Remote page, choose Mode 1, Mode 2, or Mode 3 as a serial bridge mode for HA remote of the Dante-MY16-AUD card. For details about each mode, please see "Connections for HA Control" (on page 7). Note: If the HA Remote page is not displayed on the Device View window, please check that Dante Controller v3.2.9 or later and the Dante-MY16-AUD firmware v3.3.9 or later are used. 11 www.yamahaproaudio.com