Yamaha Dante-MY16-AUD Dante-MY16-AUD and R Series HA Remote Control Guide - Page 3

Yamaha Commercial Audio System Examples Dante-MY16-AUD HA Remote Control Guide LS9 system example When inserting the Dante-MY16-AUD card into your LS9, you can remotecontrol the HA of an I/O rack on the Dante network from the LS9, with just a simple network connection. From the LS9, each Rio1608-D is recognized and controlled as two units of AD8HR (one unit for the Ri8-D). Please ensure that the card bridging an HA control signal is always inserted into slot 1 (for the LS9-32). Rio1608-D Rio1608-D Ri8-D mode 2 Slot 1: mode 2 Ri8-D LS9-16 LS9-32 PM5D system example To remote-control the HA of an I/O rack on the Dante network from the PM5D, you need to connect the REMOTE terminals between the console and the card with a serial cable (straight, female-male), in addition to the network connection. In a redundantly connected Dante network, the control signal as well as the audio signal, passes through both circuits. Therefore, even if the primary circuit is broken, the communication of HA control can continue by using the secondary circuit. Rio1608-D Primary Secondary mode 3 Rio3224-D PM5D/PM5D-RH 3 www.yamahaproaudio.com