Yamaha Dante-MY16-AUD Dante-MY16-AUD and R Series HA Remote Control Guide - Page 14

Yamaha Commercial Audio Dante-MY16-AUD HA Remote Control Guide Note: If the mixer cannot recognize HA equipment and the HA equipment does not appear on the screen of the mixer, please check the following. ・ Are the Dante-MY16-AUD firmware and Dante Controller updated to a version that supports the HA remote function? Firmware V3.3.9 or later and Dante Controller V3.2.9 or later are required. ・ (In the case where a serial cable is used) Are you using a straight cable? ・ (In the case where control is done via the Mini-YGDAI slot) Have you inserted the Dante-MY16-AUD in SLOT1? Those other than SLOT1 cannot transmit HA control signals. ・ Is the HA Remote bridge mode of Dante-MY16-AUD set properly? ・ Is AD8HR mode set on the front panel of the R series? Are all the virtual unit IDs unique to each other? ・ Ensure that a port other than REMOTE and SLOT1 is selected as a MIDI port on the MIDI SETUP screen of the digital mixer. 14 www.yamahaproaudio.com