Yamaha M3000-24 Owner's Manual - Page 11
M1-M8, M9-M12, M13/M14, M15/M16 BAL, mix level controls, switches, balance controls
View all Yamaha M3000-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
G M1-M8 mix level controls These controls combine the stereo signal from the stereo input channel into a mono signal, and send it to MIX buses 1-8. When the control is in the "v" position, the level is nominal (0 dB). Use the PRE switch (M) to switch between pre/post fader. Note: For MIX bus pairs for which the variable/fix select section (page 13) switch is set to FIX, the output level which is sent from each input channel to the bus will be fixed, and therefore the mix level control setting will have no effect. H M9-M12 switches These are on/off switches for the signals that are sent from the stereo input channel to MIX buses 9-12. I M9-M12 mix level controls These controls combine the stereo signal from the stereo input channel into a mono signal, and send it to MIX buses 9-12. When the control is in the "v" position, the level is nominal (0 dB). Use the PRE switch (M) to switch between pre/post fader. Control panel J M13/M14, M15/M16 switches These are on/off switches for the signals that are sent from the stereo input channel to MIX buses 13-16. M13 and 14, and M15 and M16 are stereo pairs, and each pair is turned on/off by one switch. K M13/M14, M15/M16 mix level controls These controls send the stereo signal from the stereo input channel to MIX buses 13/14, 15/16. When the control is in the "v" position, the level is nominal (0 dB). M13 and M14, and M15 and M16 are stereo pairs, and the output level of each pair is controlled by one knob. Use the PRE switch (P) to switch between pre/post fader. L M13/M14, M15/M16 BAL (balance) controls These controls set the left/right balance of the signals that are sent from the stereo input channel to MIX buses 13/14 or MIX buses 15/16. M PRE switches These are pre-fader/post-fader switches for the signals that are sent from the stereo input channel to the MIX buses. Pre/post can be switched independently for each group of MIX buses: 1-4, 5-8, 9-12, and 13-16. When the switch is pressed ( ), the pre-fader/postEQ signal will be sent to the corresponding group of MIX buses. L INPUT A R ST CH 1-4 L INPUT B R HA A B GAIN A HA HA g LO g LO-MID Q g HI-MID Q g HI 4 Stage EQ 4 Stage EQ PEAK NOM SIGNAL VCA EQ VCA GAIN A HA 1 2 from VCA Master 7 8 CHECK ON from Ctrl Master CONTROL ON/EDIT ST BAL MIX MIX (VARIABLE) (FIX) PFL ST 1 3 5 7 9 11 13 15 1 2 3 4 5 6 7 8 L R ON L R 2 4 6 8 10 12 14 16 PRE M1 M2 M3 M4 PRE M5 M6 M7 M8 PRE PRE M9 M10 M11 M12 M13 M14 BAL M15 M16 BAL PFL 11