Yamaha M3000-24 Owner's Manual - Page 12
ON/EDIT, CHECK, PEAK/NOM/SIGNAL, VCA GROUP, stereo switch, balance control, switch, indicators
View all Yamaha M3000-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Control panel O L BAL R ST CHECK ON ON/ EDIT PEAK NOM SIGNAL N P Q S 10 1 5 2 0 3 5 4 10 5 R 20 6 30 7 40 8 VCA 50 GROUP 60 PFL T N ST (stereo) switch When this switch is on, the signal of the input channel will be sent to the (ST) stereo bus. O BAL (balance) control This sets the left/right balance of the signal that is sent from the input channel to the ST bus. P ON/EDIT switch/ON, CHECK indicators The function of this switch and these indicators will depend on the mode of the M3000. qIn normal mode The ON/EDIT switch will turn on the stereo input channel. When on, the ON indicator will light. Channels which are turned off will send no signal to the ST bus or the MIX buses. However even in this case, you can use the PFL switch (T) to monitor the channel from the MONITOR OUT jacks or the PHONE jack. qIn check mode You can use the CHECK indicators to view the on/off status of each channel stored in a scene before you actually recall the scene. This is convenient when you wish to verify the status of each channel before you recall a scene. In check mode, you can also use the ON/EDIT switches to change only the lit/dark status of the CHECK indicators. (The actual on/off setting will not be affected.) For details on Check mode, refer to page 33. Q PEAK/NOM/SIGNAL indicators Three indicators show the level of the stereo input channel signal after it passes through the EQ. • PEAK indicator This will light when the sum of the L and R signals exceeds the nominal level by 18 dB. • NOM (nominal) indicator This will light when the sum of the L and R signals reaches nominal level (0 dB). • SIGNAL indicator This will light when the sum of the L and R signals reaches 10 dB below the nominal level. R VCA GROUP select switches These switches select the VCA master fader(s) which will control the signal output level of this stereo input channel. When you select a VCA group 1-8, the indicator located at the left of each switch will light, and the corresponding VCA master fader (VCA master section 3) will control the channel. It is possible to select two or more VCA groups for one stereo input channel, or to control two or more channels by the same VCA group. qStereo input channels for which a VCA group is selected The signal output level of the channel can be controlled both by the corresponding VCA master fader(s) and by the channel fader (S). qStereo input channels for which a VCA group is not selected The signal output level of the stereo input channel can be controlled only by the channel fader (S). Note: For details on VCA functions, refer to page 38. S Channel fader This fader adjusts the signal output level of the stereo input channel. This fader will affect the level of the signal that is sent to the ST bus and to the MIX buses (if the PRE switch is off). If one or more VCA groups are selected by the VCA GROUP select switches (R), the signal output level of that channel will also be affected by the corresponding VCA master fader(s). T PFL (pre-fader listen) switch When this switch is on ( ), the pre-fader/post-EQ signal of this stereo input channel will be sent to the PFL bus, allowing it to be monitored from the MONITOR OUT jacks or the PHONES jack. 12