Yamaha M3000-24 Owner's Manual - Page 17

A TO MATRIX STEREO A B CHECK ON C ON/EDIT AFL STEREO A 10 5 0 5 10 20 30 40 D 50 60 Control panel A TO MATRIX switch When this switch is on ( ), the ST OUT A postfader signal is sent to the matrix. B ON/EDIT switch The function of this switch and indicator will depend on the mode of the M3000. qIn normal mode The ON/EDIT switch will turn ST OUT A on/off. When on, the ON indicator will light. When off, no signal will be sent to the ST OUT A jacks, MONITOR OUT jacks, PHONES jack, MAS AFL bus, or the matrix. However even in this case, you can turn on the AFL switch (3) to monitor the pre-fader signal from the MONITOR OUT jacks or the PHONE jack. qIn check mode You can use the CHECK indicator to view the on/off status of ST OUT A stored in a scene before you actually recall the scene. In check mode, you can also use the ON/EDIT switch to change only the lit/dark status of the CHECK indicator. (The actual on/off setting will not be affected.) C AFL switch This switch allows the ST OUT A signal which is sent to the ST OUT A jacks or to the matrix to be monitored from the MONITOR OUT jacks or from the PHONES jack. When this switch is on ( ), the prefader signal will be sent to the MAS PFL bus and the post-fader signal will be sent to the MAS AFL bus, allowing you to monitor them from the MONITOR OUT jacks or the PHONES jack. When the master section MASTER PFL switch (page 19) is off you can monitor the signal of the MAS AFL bus, and when it is on you can monitor the signal of the MAS PFL bus. However if even one of the PFL switches of the input channels is turned on, the signal of the PFL bus will take priority for monitoring, and it will not be possible to monitor ST OUT A. D ST (stereo) fader This fader adjusts the final output level of ST OUT A. This fader affects the level of the signal which is sent to the ST OUT A jacks, the MONITOR OUT jacks, the PHONES jack, the MAS AFL bus, and the matrix. 17