Yamaha R-N602 Owners Manual - Page 26
Adjusting the BASS and TREBLE, controls, Adjusting the BALANCE control, Adjusting the LOUDNESS
View all Yamaha R-N602 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Playback ■ Adjusting the BASS and TREBLE controls ■ Adjusting the LOUDNESS control PHONES SPEAKERS A B 5V 1A DIMMER DISPLAY MODE MEMORY CLEAR BAND PRESET TUNING INPUT BASS TREBLE BALANCE LOUDNESS FLAT -30dB SELECT PUSH - ENTER L R RETURN CONNECT PURE DIRECT VOLUME BASS TREBLE The BASS and TREBLE controls adjust high and low frequency response. The center position produces a flat response. BASS control When you feel there is not enough bass (low frequency sound), rotate clockwise to boost. When you feel there is too much bass, rotate counterclockwise to suppress. Control range: -10 dB to +10 dB (20 Hz) TREBLE control When you feel there is not enough treble (high frequency sound), rotate clockwise to boost. When you feel there is too much treble, rotate counterclockwise to suppress. Control range: -10 dB to +10 dB (20 kHz) ■ Adjusting the BALANCE control PHONES SPEAKERS A B 5V 1A DIMMER DISPLAY MODE MEMORY CLEAR BAND PRESET TUNING INPUT BASS TREBLE BALANCE LOUDNESS FLAT -30dB SELECT PUSH - ENTER L R RETURN CONNECT PURE DIRECT VOLUME LOUDNESS VOLUME HOME RETURN SETUP VOLUME OPTION NOW PLAYING MUTE VOLUME +/- Retain a full tonal range at any volume level, thus compensating for the human ears' loss of sensitivity to high and low-frequency ranges at low volume. CAUTION If the PURE DIRECT switch is turned on with the LOUDNESS control set at a certain level, the input signals bypass the LOUDNESS control, resulting in a sudden increase in the sound output level. To prevent your ears or the speakers from being damaged, be sure to press the PURE DIRECT switch after lowering the sound output level or after checking that the LOUDNESS control is properly set. 1 Set the LOUDNESS control to the FLAT position. PHONES SPEAKERS A B 5V 1A DIMMER DISPLAY MODE MEMORY CLEAR BAND PRESET TUNING INPUT BASS TREBLE BALANCE LOUDNESS FLAT -30dB SELECT PUSH - ENTER L R RETURN CONNECT PURE DIRECT VOLUME BALANCE The BALANCE control adjusts the sound output balance of the left and right speakers to compensate for sound imbalance caused by speaker locations or listening room conditions. 2 Rotate the VOLUME control on the front panel (or press VOLUME +/- on the remote control) to set the sound output level to the loudest listening level that you would listen to. 3 Rotate the LOUDNESS control until the desired volume is obtained. 22 En y After setting the LOUDNESS control, enjoy listening to music at your preferred volume level. If the effect of the LOUDNESS control setting is too strong or weak, readjust the LOUDNESS control.