Yamaha R-N602 Owners Manual - Page 52

Configuring the system settings (ADVANCED SETUP menu) Configure the system settings of the unit while viewing the front display. 1 Turn off the unit. 2 While holding down RETURN on the front panel, press A (power). A (power) RETURN PHONES SPEAKERS A B 5V 1A DIMMER DISPLAY MODE MEMORY CLEAR BAND PRESET TUNING INPUT BASS TREBLE BALANCE LOUDNESS FLAT -30dB SELECT PUSH - ENTER L R RETURN CONNECT PURE DIRECT VOLUME DISPLAY SELECT/ENTER 3 Rotate SELECT/ENTER to select an item. 4 Press SELECT/ENTER to select a setting. 5 Press A (power) to set the unit to turn off and turn it on again. The new settings take effect. ADVANCED SETUP menu items Item SP IMP. REMOTE ID INIT UPDATE VERSION Function Changes the speaker impedance setting. Selects the unit's remote control ID. Restores the default settings. Updates the firmware. Checks the version of firmware currently installed on the unit. Page 48 48 48 49 49 Changing the speaker impedance setting (SP IMP.) SP IMP.••8¬MIN Change the unit's speaker impedance settings depending on the impedance of the speakers connected. Settings 4  MIN 8  MIN (Default) Select this option when you connect speakers with an impedance of 4 ohms to less than 8 ohms to the unit. Select this option when you connect speakers with an impedance of 8 ohms or more to the unit. Selecting the remote control ID (REMOTE ID) REMOTE ID•AUTO When using multiple receivers in the same room, setting the remote control ID of this unit to ID1 (and setting the another receiver to other than ID1) can prevent interference from other remote controls. Settings ID1, AUTO (default) Restoring the default settings (INIT) INIT••••CANCEL Restores the default settings for the unit. Choices ALL NETWORK CANCEL Restores the default settings for the unit. Initialize all of the network, Bluetooth and USB settings. When performing the initialization, the preset (p. 42) registered by NET/USB input will be cleared. Does not perform an initialization. 48 En