Yamaha RX-V2200 Owner'w Manual - Page 40

TUNING Connecting the Antennas Both AM and FM indoor antennas are included with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals. FREQUENCY STEP switch (China and General models only) 100kHz/10kHz Because the interstation frequency spacing differs in different areas, set the 50kHz/9kHz FM AM FREQUENCY STEP FREQUENCY STEP switch (locating on the rear panel) according to the frequency spacing in your area. North, Central and South America: 100 kHz/10 kHz Other area: 50 kHz/9 kHz Before setting this switch, disconnect the AC power plug of this unit from the AC outlet. I Connecting the AM loop antenna 1 Set up the AM loop antenna, then connect it. 2 Press and hold the tab to insert the AM loop antenna lead wires into the AM ANT and GND terminals. AM loop antenna (included) (U.S.A. model) COMPONENT VIDEO PR/ CR PB/ CB Y DVD Indoor FM antenna (included) 21 3 3 Orient the AM loop antenna for the beat reception. D-TV / LD MONITOR OUT TUNER AM ANT GND 75Ω UNBAL. FM ANT CONTROL OU Ground (GND terminal) For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth. I Connecting the indoor FM antenna Connect the included indoor FM antenna to the 75Ω UNBAL. FM ANT terminal. y • The AM loop antenna can be removed from the stand and attached to a wall, etc. Notes • The AM loop antenna should be placed away from this unit. • The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit. A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, an outdoor antenna may improve the quality. Consult the nearest authorized YAMAHA dealer or service center about the outdoor antennas. 36