Yamaha RX-V2200 Owner'w Manual - Page 50

REMOTE CONTROL FEATURES I Operating the macro TRANSMIT RE-NAME CLEAR LEARN MACRO MACRO OFF ON SYSTEM POWER STANDBY A B PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD MACRO MACRO ON/OFF Macro buttons 1 Set MACRO ON/OFF to ON. 2 Press a macro button. Notes • When you have finished using the Macro feature, set MACRO ON/OFF to OFF. • While this unit is carrying out a macro program, this unit does not receive any other button's function until the macro operation has been completed (the TRANSMIT indicator stops flashing). • Continue to aim the remote control at the component the macro is operating until the macro operation has been completed. I Programming a macro You can program your own macros and use the Macro feature to transmit many remote control commands by pressing a single button. Notes • The factory-set macro is not cleared when a new macro is programmed for a button. The factory-set macro can be used again when the programmed macro is cleared. • It is not possible to add a new signal (macro step) to the factory-set macro. Programming a macro changes all macro contents. • A macro programming is used to transmit learning or setup (or YAMAHA preset) button signals of this remote control to a macro button. If necessary, set up the manufacturer code or program a function with the remote control for your component. • This remote control handles button signals that operate continuously, such as volume control, as short time interval codes. Macro programming that include these types of macro steps are therefore not recommended. 1 Press MACRO by using a ballpoint pen or similar object. "MCR ?" appears in the display window. MACRO 2 Press a macro button for which you want to program the macro operation. The button you chose for programming the macro operation and the selected component name appear alternately in the display window. A B PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD Note • "AGAIN" appears in the display window when a button other than the macro buttons is pressed. y • If you want to change the source component, use SOURCE SELECT k / n or input selector buttons. When you use the input selector buttons, selecting the input is programmed as a macro step, whereas SOURCE SELECT k / n only changes the component. 3 Press the buttons of the functions that you want to include in the macro operation sequence in order. y • You can set up to 10 steps (10 functions). After you have set 10 steps, "FULL" appears and the remote control automatically exits from the macro mode. SYSTEM POWER STANDBY A B PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD TITLE 6CH INPUT SOURCE DISPLAY MENU SELECT SEARCH POWER REC STOP ENTER SOUND - CHAPTER + PAUSE 1 PLAY 2 MCR 1 : DVD a MCR 2 : DVD p indicate the number of macro steps you entered appear alternately so that you can set up the next step Note • If you do not press any button within 30 seconds during steps 2 and 3, the macro programming process is canceled. If this happens, start over from step 1. Note • "NG" appears in the display window when programming has not been done correctly. In this case, start over from step 2. 46