Yamaha RX-V2200 Owner'w Manual - Page 67

INTRODUCTION PREPARATION 9 PARAM. INI (parameter initialization) Use this feature to initialize the parameters for each DSP program within a DSP program group. When you initialize a DSP program group, all of the parameter values within that group revert to their initial settings. Press the corresponding numeric button for the DSP program that you want to initialize. The asterisk (*) next to the program number means that the parameter values have been changed. 9 PARAM. INI 1 2 3 *4 *5 6 7 8 9 *10 11 Press No. Key Notes • You cannot initialize the individual DSP programs within a group separately. • The parameter values of the DSP programs do not change if you initialize a program group that does not have the asterisk mark (*). • When "14 MEMORY GUARD" is set to ON (see page 65), you cannot initialize any program groups. • Once you initialize a DSP program group, you cannot automatically revert to the previous parameter settings. SET MENU 10 LFE LEVEL This setting is effective only when this unit decodes Dolby Digital or DTS signals. Use this feature to adjust the output level of the LFE (low-frequency effect) channel when playing back a Dolby Digital or DTS signal. The LFE signal carries the low-frequency special effect sound which is only added to certain scenes. Control range (dB): -20 to 0 for both SPEAKER and HEADPHONE Initial setting: 0 dB for both SPEAKER and HEADPHONE 1 Press k / n to select the item to be adjusted. 10 LFE LEVEL ≥ SPEAKER 0dB HEADPHONE............0dB 2 Press - to adjust the LFE level. 10 LFE LEVEL ≥ SPEAKER 11dB HEADPHONE............0dB Note • Adjust the LFE level according to the capacity of your subwoofer or headphones. BASIC OPERATION ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 63