Yamaha RX-V2200 Owner'w Manual - Page 51

INTRODUCTION PREPARATION BASIC OPERATION 4 Press MACRO again when MACRO the operation sequence you want to program is complete. Note • "ERROR" appears in the display window under the following circumstances: - when pressing more than one button at once; or - when MACRO ON/OFF is switched to another position. Memory back-up If the remote control is without batteries for more than 3 minutes, or if exhausted batteries remain in the remote control, the contents of the memory may be cleared. When the memory is cleared, insert new batteries, set up the manufacturer code and program any acquired functions that may have been cleared. Changing the Source Name in the Display Window You can change the name that appears in the display window on the remote control if you want to use the different name from the original input selector button names. This is useful when different component is set in the input selector button. 1 Press an input selector button, Å or ı to select the source component you want to rename. The selected component name appears in the display window. A B PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD REMOTE CONTROL FEATURES y • If you continuously want to rename another source component, press ENTER and repeat steps 1, 3 and 4. 5 Press RE-NAME again to exit from the renaming mode. RE-NAME Clearing Learned Functions, Macros, Renamed Source Names, and Setup Manufacturer Codes 1 Press an input selector button, Å or ı to select the source component you want to clear the function, Macros, names or manufacturer codes. The selected component name appears in the display window. A B PHONO V-AUX TUNER MD/TAPE CD-R CD D-TV/LD CBL/SAT VCR 1 VCR2/DVR DVD 2 Press CLEAR by using a ballpoint pen or similar object. CLEAR Note • If you do not press any button within 30 seconds during steps 2 and 3, the clearing process is canceled. If this happen, start over from step 1. 2 Press RE-NAME by using RE-NAME a ballpoint pen or similar object. 3 Press k / n to select and enter a character. Pressing n changes the character in the following order: A to Z, a to z, 0 to 9, space, - (hyphen) and / (slash). (Pressing k goes in the reverse order.) ENTER 4 Press l / h to move the cursor to the next position. ENTER ADVANCED OPERATION ADDITIONAL INFORMATION APPENDIX English 47