Yamaha YSP 1000 Owner's Manual - Page 39
Error messages for AUTO SETUP, Before the AUTO SETUP procedure starts - problems
UPC - 027108924274
View all Yamaha YSP 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
■ Error messages for AUTO SETUP AUTO SETUP Before the AUTO SETUP procedure starts Error message Cause ERROR E-2 No MIC Detected. Please check MIC connection and re-try. The optimizer microphone is not connected to this unit. While the AUTO SETUP procedure is in progress- Remedy Connect the optimizer microphone to this unit. See page 29 Error message ERROR E-1 Please test in more quiet environment. ERROR E-2 No MIC detected. Please check MIC connection and re-try. ERROR E-3 Unexpected control is detected. Please re-try. ERROR E-4 Please check MIC position. MIC should be set in front of YSP. ERROR E-5 Please check MIC position. MIC should be set above 2m/6.5ft. ERROR E-6 Volume level is smaller than expected. Please check MIC position/connection and re-try. ERROR E-7 Unexpected Error Happened. Please re-try. Cause Remedy There is too much unwanted noise in your listening room. The optimizer microphone was disconnected while the AUTO SETUP procedure was in progress. Some other operations were performed on this unit while the AUTO SETUP procedure was in progress. The optimizer microphone is not placed in front of this unit. Make sure that your listening room is as quiet as possible. You may want to choose certain hours during the day when there is not much noise coming from outside. Make sure that the optimizer microphone is firmly connected to this unit. Do not perform any other operations while the AUTO SETUP procedure is in progress. Make sure that the optimizer microphone is installed in front of this unit. See page - 29 - 29 The optimizer microphone is not placed Make sure that the optimizer microphone 29 in the right distance from this unit. is installed more than 2 m from the front of this unit and within 1 m from the center height of this unit. The optimizer microphone cannot collect Make sure that the optimizer microphone 29 the sound produced by this unit because is firmly connected to this unit and the sound output level is too low. placed in a proper location. If the problem persists, contact the nearest YAMAHA service center for assistance. An internal system error occurred. Repeat the AUTO SETUP procedure. - SETUP 35