Zanussi ZOB35301XK Product Manaul - Page 14
Cleaning the oven door, Caution, Installing the door and the glass panel - bulb
View all Zanussi ZOB35301XK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Put a cloth on the bottom of the oven to prevent damage to the oven light and glass cover. Always hold the halogen lamp with a cloth to prevent grease residue from burning on the lamp. 1. Turn the glass cover counterclockwise to remove it. 2. Clean the glass cover. 3. Replace the oven light bulb with an appli- cable 300 °C heat-resistant oven light bulb. Use the same oven lamp type. 4. Install the glass cover. Cleaning the oven door The oven door has two glass panels. You can remove the oven door and the internal glass panel to clean it. The oven door can close if you try to remove the internal glass panel before you remove the oven door. Caution! Do not use the appliance without the glass panels. 3 Close the oven 4 Put the door on a door to the first open- soft cloth on a stable ing position (halfway). surface. Then pull forward and remove the door from its seat. 90° 5 Release the locking system to remove the internal glass panel. 6 Turn the two fasteners by 90° and remove them from their seats. 1 Open the door 2 Lift and turn the fully and hold the two levers on the two door hinges. hinges. 14 12 7 Carefully lift (step 1) and remove (step 2) the glass panel. Clean the glass panel with water and soap. Dry the glass panel carefully. Installing the door and the glass panel When the cleaning is completed, install the glass panel and the oven door. Do the above steps in the opposite sequence. The screen-printing zone must face the inner side of the door. Make sure that after the instal- www.zanussi.com