ZyXEL GS-105I User Guide - Page 150
Adding a QoS Queue
View all ZyXEL GS-105I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
Chapter 10 Quality of Service (QoS) Table 46 Network Setting > QoS > Queue Setup (continued) LABEL DESCRIPTION Buffer Management This shows the queue management algorithm used for this queue. Queue management algorithms determine how the Zyxel Device should handle packets when it receives too many (network congestion). Rate Limit This shows the maximum transmission rate allowed for traffic on this queue. Rate limit 0 means there's no rate limit on this queue. Modify Click the Edit icon to edit the queue. Click the Delete icon to delete an existing queue. Note that subsequent rules move up by one when you take this action. 10.4.1 Adding a QoS Queue Click Add New Queue or the Edit icon in the Queue Setup screen to configure a queue. Figure 85 Queue Setup: Add The following table describes the labels in this screen. Table 47 Queue Setup: Add LABEL DESCRIPTION Active Name Interface Click this switch to enable or disable the queue. When the switch turns blue enabled. Otherwise, it is not. Enter the descriptive name of this queue. Select the interface to which this queue is applied. , the function is Priority This field is read-only if you are editing the queue. Select the priority level (from 1 to 7) of this queue. The smaller the number, the higher the priority level. Traffic assigned to higher priority queues gets through faster while traffic in lower priority queues is dropped if the network is congested. PX7511-B0 User's Guide 150