ZyXEL GS-105I User Guide - Page 156
QoS Shaper Setup
View all ZyXEL GS-105I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 156 highlights
Chapter 10 Quality of Service (QoS) Table 49 Classification Setup: Add/Edit (continued) LABEL DESCRIPTION 802.1P Mark Select a priority level with which the Zyxel Device replaces the IEEE 802.1p priority field in the packets. If you select Unchange, the Zyxel Device keep the 802.1p priority field in the packets. Step4: Class Routing Forward to Interface Select a WAN interface through which traffic of this class will be forwarded out. If you select Unchange, the Zyxel Device forward traffic of this class according to the default routing table. Step5: Outgoing Queue Selection To Queue Index Select a queue that applies to this class. Cancel OK You should have configured a queue in the Queue Setup screen already. Click Cancel to exit this screen without saving. Click OK to save your changes. 10.6 QoS Shaper Setup This screen lets you use the token bucket algorithm to allow a certain amount of large bursts of traffic while keeping most outgoing traffic at the average rate. Click Network Setting > QoS > Shaper Setup. The screen appears as shown. Figure 88 Network Setting > QoS > Shaper Setup The following table describes the labels in this screen. Table 50 Network Setting > QoS > Shaper Setup LABEL DESCRIPTION Add New Shaper # Status Interface Rate Limit Modify Click this to create a new entry. This is the index number of the entry. This field displays whether the shaper is active or not. A yellow bulb signifies that this policer is active. A gray bulb signifies that this shaper is not active. This shows the name of the Zyxel Device's interface through which traffic in this shaper applies. This shows the average rate limit of traffic bursts for this shaper. Click the Edit icon to edit the shaper. Click the Delete icon to delete an existing shaper. Note that subsequent rules move up by one when you take this action. PX7511-B0 User's Guide 156