ZyXEL GS2200-8HP User Guide - Page 209
Advanced Application > IP Source Guard > ARP Inspection >, Con gt; Port
View all ZyXEL GS2200-8HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
Chapter 25 IP Source Guard open this screen, click Advanced Application > IP Source Guard > ARP Inspection > Configure > Port. Figure 130 ARP Inspection Port Configure The following table describes the labels in this screen. Table 77 ARP Inspection Port Configure LABEL Port Trusted State DESCRIPTION This field displays the port number. If you configure the * port, the settings are applied to all of the ports. Select whether this port is a trusted port (Trusted) or an untrusted port (Untrusted). The Switch does not discard ARP packets on trusted ports for any reason. The Switch discards ARP packets on untrusted ports in the following situations: Limit Rate (pps) Burst interval (seconds) • The sender's information in the ARP packet does not match any of the current bindings. • The rate at which ARP packets arrive is too high. You can specify the maximum rate at which ARP packets can arrive on untrusted ports. These settings have no effect on trusted ports. Specify the maximum rate (1-2048 packets per second) at which the Switch receives ARP packets from each port. The Switch discards any additional ARP packets. Enter 0 to disable this limit. The burst interval is the length of time over which the rate of ARP packets is monitored for each port. For example, if the rate is 15 pps and the burst interval is 1 second, then the Switch accepts a maximum of 15 ARP packets in every one-second interval. If the burst interval is 5 seconds, then the Switch accepts a maximum of 75 ARP packets in every five-second interval. Enter the length (1-15 seconds) of the burst interval. GS2200-8/24 User's Guide 209