ZyXEL GS2200-8HP User Guide - Page 210
Advanced, Application > IP Source Guard > ARP Inspection > Con gt; VLAN
View all ZyXEL GS2200-8HP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 210 highlights
Chapter 25 IP Source Guard Table 77 ARP Inspection Port Configure (continued) LABEL DESCRIPTION Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Cancel Click this to reset the values in this screen to their last-saved values. 25.9.2 ARP Inspection VLAN Configure Use this screen to enable ARP inspection on each VLAN and to specify when the Switch generates log messages for receiving ARP packets from each VLAN. To open this screen, click Advanced Application > IP Source Guard > ARP Inspection > Configure > VLAN. Figure 131 ARP Inspection VLAN Configure The following table describes the labels in this screen. Table 78 ARP Inspection VLAN Configure LABEL DESCRIPTION VLAN Use this section to specify the VLANs you want to manage in the section below. Start VID Enter the lowest VLAN ID you want to manage in the section below. End VID Enter the highest VLAN ID you want to manage in the section below. Apply Click this to display the specified range of VLANs in the section below. VID This field displays the VLAN ID of each VLAN in the range specified above. If you configure the * VLAN, the settings are applied to all VLANs. Enabled Select Yes to enable ARP inspection on the VLAN. Select No to disable ARP inspection on the VLAN. 210 GS2200-8/24 User's Guide