ZyXEL NWA110AX User Guide - Page 45
Hardware, NWA/WAC/WAX Series User's Guide, NWA1302-AC LEDs
View all ZyXEL NWA110AX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 3 Hardware Figure 19 NWA1302-AC LEDs The following table describes the LEDs. Table 14 NWA1302-AC LEDs LED COLOR STATUS PWR/SYS Amber Green Blinks amber for 1 second and green for 1 second alternatively. Green On Slow Blinking (On for 1 sec, Off for 1 sec) Fast Blinking (On 50 ms, Off 50 ms) Red On Management Green Fast Blinking (On for 50 ms, Off for 50 ms) Slow Blinking (Blink for 3 times, Off for 3 sec) On Slow Blinking (On for 1 sec, Off for 1 sec) Amber Green Amber Green Off Blinks amber for 1 second and green for 1 second alternatively Blinks amber and green alternatively 3 times and then turns solid green for 3 seconds. DESCRIPTION The LED blinks amber and green alternatively when the Zyxel Device is booting up. The Zyxel Device is ready for use. The wireless module of the Zyxel Device is disabled or failed. The Locator LED is on. There is a system error and the Zyxel Device cannot boot up, or the Zyxel Device suffered a system failure. The Zyxel Device is doing firmware upgrade. The Uplink interface is down. The Zyxel Device is managed by the NCC. The Zyxel Device is using default wireless settings, or the Zyxel Device is connected to the NCC but is unregistered with the NCC. The Zyxel Device is searching for (discovering) the NCC. The NCC is connecting to the registered Zyxel Device. The Zyxel Device is in standalone mode. NWA/WAC/WAX Series User's Guide 45