ZyXEL NWA110AX User Guide - Page 51
Hardware, NWA/WAC/WAX Series User's Guide, WAC5302D-S LEDs
View all ZyXEL NWA110AX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Figure 22 WAC5302D-S LEDs Chapter 3 Hardware The following table describes the LEDs. Table 17 WAC5302D-S LEDs LED COLOR STATUS PWR/SYS Amber Green Blinks amber for 1 second and green for 1 second alternatively. Green On Slow Blinking (On for 1s, Off for 1s) Fast Blinking (On 50 ms, Off 50 ms) Red On Management Green Fast Blinking (On for 50ms, Off for 50 ms) Slow Blinking (Blink for 3 times, Off for 3s) Slow Blinking (Blink for 2 times, Off for 3s) On Slow Blinking (Blink for 3 times, Off for 3s) Slow Blinking (On for 1s, Off for 1s) Off DESCRIPTION The LED blinks amber and green alternatively when the WAC is booting up. The Zyxel Device is ready for use. The wireless module of the Zyxel Device is disabled or failed. The Locator LED is on. There is system error and the Zyxel Device cannot boot up, or the Zyxel Device suffered a system failure. The Zyxel Device is doing firmware upgrade. The Uplink interface is down. The Zyxel Device is managed by an AC and the uplink is disconnected. The Zyxel Device is managed by a controller. The Zyxel Device is searching (discovery) for a controller. The Zyxel Device is using default wireless settings, or the Zyxel Device is connected to the NCC but is unregistered with the NCC. The Zyxel Device is in standalone mode. NWA/WAC/WAX Series User's Guide 51