ZyXEL NXC2500 User Guide - Page 130

Chapter 8 Wireless Table 56 Configuration > Wireless > AP Management > Mgmt. AP List > Edit AP List (continued) LABEL DESCRIPTION Automatically Extinguish After Enter a time interval between 1 and 60 minutes to stop the locator LED from blinking. The locator LED will start to blink for the number of minutes set here. If you make changes to the time default setting, it will be stored as the default when the AP restarts. Reset AP Configuration This section is available only when the AP is online. Apply Factory Default Click the button to reset all of the AP settings to the factory defaults. OK Click OK to save your changes back to the NXC. Cancel Click Cancel to close the window with changes unsaved. 8.3.2 AP Policy Use this screen to configure the AP controller's IP address on the managed APs and determine the action the managed APs take if the current AP controller fails. Click Configuration > Wireless > AP Management > AP Policy to access this screen. Figure 71 Configuration > Wireless > AP Management > AP Policy Each field is described in the following table. Table 57 Configuration > Wireless > AP Management > AP Policy LABEL DESCRIPTION General Settings Force Override Controller IP Config on AP Override Type Select this to have the NXC change the AP controller's IP address on the managed AP(s) to match the configuration in this screen. Select Auto to have the managed AP(s) automatically send broadcast packets to find any other available AP controllers. Select Manual to replace the AP controller's IP address configured on the managed AP(s) with the one(s) you specified below. NXC Series User's Guide 130