ZyXEL VES1724-56B2 User Guide - Page 197
Viewing and Editing Classifier Configuration
![]() |
View all ZyXEL VES1724-56B2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
Chapter 20 Classifier Table 81 Advanced Application > Classifier (continued) LABEL IP Address/ Address Prefix DESCRIPTION Enter a destination IP address in dotted decimal notation. Specify the address prefix by entering the number of ones in the subnet mask. Socket Number Note: You must select either UDP or TCP in the IP Protocol field before you configure the socket numbers. Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second option and enter a TCP/UDP protocol port number. Refer to Table 85 on page 198 for more information. Add Cancel Clear Click Add to insert the entry in the summary table below and save your changes to the Switch's run-time memory. The Switch loses these changes if it is turned off or loses power, so use the Save link on the top navigation panel to save your changes to the non-volatile memory when you are done configuring. Click Cancel to reset the fields back to your previous configuration. Click Clear to set the above fields back to the factory defaults. 20.3 Viewing and Editing Classifier Configuration To view a summary of the classifier configuration, scroll down to the summary table at the bottom of the Classifier screen. To change the settings of a rule, click a number in the Index field. Note: When two rules conflict with each other, a higher layer rule has priority over lower layer rule. Figure 120 Advanced Application > Classifier: Summary Table The following table describes the labels in this screen. Table 82 Classifier: Summary Table LABEL Index Active Name Rule Delete Cancel DESCRIPTION This field displays the index number of the rule. Click an index number to edit the rule. This field displays Yes when the rule is activated and No when it is deactivated. This field displays the descriptive name for this rule. This is for identification purpose only. This field displays a summary of the classifier rule's settings. Click Delete to remove the selected entry from the summary table. Click Cancel to clear the Delete check boxes. VES1724-56 User's Guide 197
![](/manual_guide/products/zyxel-ves172455c-user-guide-fbc1f83/197.png)