ZyXEL VMG9823 User Guide - Page 21

Chapter 1 Introducing the VMG Table 1 LED Descriptions (continued) LED COLOR STATUS DESCRIPTION Green On A SIP account is registered for the phone port. VoIP 1 VoIP 2 Orange Blinking On A telephone connected to the phone port has its receiver off of the hook or there is an incoming call. A SIP account is registered for the phone port and there is a voice message in the corresponding SIP account. Blinking A telephone connected to the phone port has its receiver off of the hook and there is a voice message in the corresponding SIP account. Off The phone port does not have a SIP account registered. 1.6 The RESET Button If you forget your password or cannot access the Web Configurator, you will need to use the RESET button at the back of the device to reload the factory-default configuration file. This means that you will lose all configurations that you had previously and the password will be reset to "1234". 1 Make sure the POWER LED is on (not blinking). 2 To set the device back to the factory default settings, press the RESET button for ten seconds or until the POWER LED begins to blink and then release it. When the POWER LED begins to blink, the defaults have been restored and the device restarts. 1.7 Wireless Access The VMG is a wireless Access Point (AP) for wireless clients, such as notebook computers or PDAs and iPads. It allows them to connect to the Internet without having to rely on inconvenient Ethernet cables. You can configure your wireless network in either the built-in Web Configurator, or using the WPS button. Figure 6 Wireless Access Example VMG9823-B10A User's Guide 21