2013 Chevrolet Volt Owner Manual - Page 261

Vehicle Care See Maintenance Schedule on page 11‑3 for more information. If driving in dusty/dirty conditions, inspect the air filter at each engine oil change. 2. Air Duct Clamp 3. Electrical Connector To inspect or replace the air filter: 1. Open the hood. See Hood on page 10‑6. 2. Locate the engine air cleaner/ filter assembly on the passenger side of the engine compartment. See Engine Compartment Overview on page 10‑8. 3. Disconnect the air duct by loosening the air duct clamp (2). 4. Disconnect the electrical connector (3). 5. Lift the retaining clips (1) from the engine air cleaner/filter assembly. 6. Turn and tilt the air cleaner cover slightly upward and slide it out. Remove the air filter. 10-13 How to Reinstall the Engine Air Filter 1. Install the air filter into the engine air cleaner/filter assembly. The outer air filter seal must be fitted properly in the engine air cleaner/filter assembly. 2. Replace the air cleaner cover by lowering it to meet the bottom of the engine air cleaner/filter assembly. Place the retaining clips (1) on the engine air cleaner/filter assembly and secure. The rear tabs must be secured into the lower portion of the air cleaner. 3. Reconnect the air duct and tighten the air duct clamp (2). 4. Reconnect the electrical connector (3). How to Inspect the Engine Air Filter To inspect the air filter, remove it from the engine air cleaner/filter assembly and lightly shake to release loose dust and dirt. If the air filter remains covered with dirt, a new air filter is required. 1. Retaining Clips