2014 Chevrolet Silverado 3500 HD Crew Cab Owner Manual - Page 112

3-50 Seats and Restraints Be sure to read the instructions following to properly install a child restraint using these loops. Do not secure a child restraint in a position without a top tether anchor if a national or local law requires that the top tether be attached, or if the instructions that come with the child restraint say that the top tether must be attached. Crew Cab Shown, Extended Cab Similar For crew and extended cab models, the top tether anchors are the loops located near the top of the seatback for each rear seating position. These loops will be used to route the top tether through, as well as, to secure the top tether in the vehicle. Be sure to use an anchor (loop) located on the same side of the vehicle as the seating position where the child restraint will be placed. According to accident statistics, children and infants are safer when properly restrained in a child restraint system or infant restraint system secured in a rear seating position. See Where to Put the Restraint on page 3-45 for additional information. Do not install a child restraint in the center seat position. See Securing Child Restraints (Center Front Seat Position) on page 3-58 or Securing Child Restraints (Right Front Seat Position) on page 3-58 or Securing Child Restraints (Rear Seat Position) on page 3-55 for more information. For regular cab models, the top tether anchors are located under covers on the back panel behind the passenger seat. Remove the trim plug to access the anchor. Be sure to use an anchor located on the same side of the vehicle as the seating position where the child restraint will be placed.