2014 Chevrolet Silverado 3500 HD Crew Cab Owner Manual - Page 288
2014 Chevrolet Silverado 3500 HD Crew Cab Manual
Page 288 highlights
9-22 Driving and Operating and on the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the gross axle weight ratings (GAWR). The total axle loads should not exceed your vehicle's gross vehicle weight rating (GVWR). These ratings are given on the vehicle certification label attached to the rear edge of the driver door. See "Certification/Tire Label" under Vehicle Load Limits on page 9-15. If weight ratings are exceeded, move or remove items to bring all weights below the ratings. See your dealer for more information on curb weights, cargo weights, Cargo Weight Rating and the correct center of gravity zone. of camper cargo, and the weight of passengers in the camper. The total cargo load should not exceed the truck's cargo weight rating, and the camper's center of gravity (A) should fall within the truck's recommended center of gravity zone (B) when installed. Any accessories or other equipment that are added to the vehicle must be weighed. Then, subtract this extra weight from the CWR. This extra weight may shorten the center of gravity zone of the vehicle. If the slide-in camper and its load weighs less than the CWR, the center of gravity zone for your vehicle may be larger. Secure loose items to prevent weight shifts that could affect the balance of the vehicle. When the truck‐camper is loaded, drive to a scale and weigh on the front Starting and Operating New Vehicle Break-In Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: . Keep the vehicle speed at 88 km/h (55 mph) or less for the first 805 km (500 miles). Do not drive at any one constant speed, fast or slow, for the first 805 km (500 miles). Do not make full-throttle starts. Avoid downshifting to brake or slow the vehicle. Avoid making hard stops for the first 322 km (200 miles) or so. During this time the new brake linings are not yet broken in. Hard stops with new linings can mean premature wear and earlier replacement. Follow this . .