2014 Chevrolet Silverado 3500 HD Crew Cab Owner Manual - Page 286

9-20 Driving and Operating Maximum Weight Structural members (A) and (B) are included in the pick-up box design. Additional accessories should use these load points. Depending on the accessory design, use a spacer under the accessory at the load points to remove gap. The holes for the Cargo Management System (C) are not intended for attachment of aftermarket equipment. See www.gmupfitter.com for additional pick-up box load bearing structural information. carry inside your vehicle. Be sure to weigh your vehicle before you buy and install the new equipment. Notice: Overloading the vehicle may cause damage. Repairs would not be covered by the vehicle warranty. Do not overload the vehicle. Remember not to exceed the Gross Axle Weight Rating (GAWR) of the front or rear axle. Maximum * Equipment Weight Ladder Rack and Cargo 340 kg (750 lbs) * Equipment * The combined weight for all rail-mounted equipment should not exceed 454 kg (1,000 lbs). Loading Points Truck-Camper Loading Information A vehicle-specific Truck‐Camper Loading Information label is attached to the inside of the vehicle's glove box. This label indicates if a slide-in camper can be carried, how much of a load the vehicle can carry, and how to correctly spread out the load. It will help to match the right slide in camper to the vehicle. Cross Toolbox 181 kg and Cargo (400 lbs) Side Boxes and Cargo 113 kg per side (250 lbs per side) A. Primary Load Points B. Secondary Load Areas C. Cargo Management Option Holes