2006 Lincoln Navigator Owner Guide 2nd Printing - Page 124

Lights 1. Make sure the headlamp switch is in the OFF position and the engine is not running. 2. Disconnect the electrical connector from the foglamp bulb. 3. Rotate the foglamp bulb counterclockwise and remove from the foglamp (the rear side of the foglamp is shown). 4. Install the foglamp bulb in foglamp by rotating clockwise. 5. Connect the electrical connector to the new foglamp bulb. Replacing tail lamp bulbs 1. Make sure the headlamp switch is in the OFF position. 2. Open the liftgate to expose the lamp assembly screws. 3. Remove the two screws from the lamp assembly. 4. Carefully pry the lamp assembly away from the vehicle, by pulling the assembly directly straight out, to expose the bulb socket. DO NOT TIP THE LAMP ASSEMBLY SIDEWAYS. 5. Rotate the bulb socket counterclockwise and remove from lamp assembly. 6. Pull bulb straight out of socket and push in the new bulb. 7. Install the bulb socket into the lamp assembly and rotate clockwise. 8. Install the lamp assembly on the vehicle and secure with two screws. Replacing back-up lamp bulbs The back-up lamp bulbs are located behind the liftgate trim panels. 124 2006 Navigator (nav) Owners Guide (post-2002-fmt) USA (fus)