2006 Lincoln Navigator Owner Guide 2nd Printing - Page 180

Locks and Security 2. Press the 1 • 2 control within five seconds of Step 1. 3. Enter your personal 5-digit code. Enter each digit within five seconds of previous one. 4. After the code is entered, the locks will cycle, confirming that the new code has been set. Do not set a code that includes five of the same number or presents them in sequential order. Thieves can easily figure out these types of codes. Your personal code does not replace the permanent code that your authorized dealer gave you. You can use either code to unlock your vehicle. If a second personal code is entered, the module will erase the first personal code in favor of the new code. If you wish to erase your personal code, use the following instructions: 1. Enter the factory set code. 2. Press the 1 • 2 control and release. The system will now only respond to the factory set code. Unlocking and locking the doors, liftgate and liftgate window using keyless entry To unlock the driver's door, enter the factory set 5-digit code or your personal code. Each number must be pressed within five seconds of each other. The interior lamps will illuminate. To unlock all doors and liftgate, press the 3 • 4 control within five seconds. To open the liftgate window, press the 5 • 6 control within five seconds. To lock all doors, liftgate and liftgate window, press the 7 • 8 and the 9 • 0 at the same time. Note: The driver's door must be closed. You do not need to enter the keypad code first. Activating/deactivating autolock with the keyless entry system 1. Turn the ignition to the 1 (OFF/LOCK) position. 2. Close all the doors, the liftgate and liftgate window. 3. Enter the 5-digit entry code 4. Press and hold the 7 • 8. While holding the 7 • 8 press the 3 • 4. 180 2006 Navigator (nav) Owners Guide (post-2002-fmt) USA (fus)