2006 Saab 9-2X Owner's Manual - Page 116

3-14 Instruments and controls Always make sure this light is out before you start to drive. ¢ Selector lever position indicator (AT vehicles) P R N ¢ High beam indicator light This light shows that the headlights are in the high beam mode. This indicator light also comes on when the headlight flasher is operated. ¢ All-Wheel Drive warning light (AWD AT vehicles) Continuing to drive with the AWD warning light flashing can damage the powertrain. If the AWD warning light starts to flash, promptly park in a safe place and check whether the tires have differing diameters and whether any of the tires has an excessively low inflation pressure. The All-Wheel Drive warning light comes on when the ignition switch is turned to the "ON" position and goes out after the engine has started. This light comes on when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for maintenance or similar purposes (Non-turbo vehicles). It flashes if the vehicle is driven with tires of differing diameters fitted on the wheels or with an excessively low air pressure in any of the tires. D 3 2 1 300630 ¢ Cruise control indicator light The cruise control indicator light comes on when the ignition switch is turned to the "ON" position and goes out after approximately three seconds. This light comes on when the "CRUISE" main switch is pressed. If it flashes during driving, deactivate the cruise control system and contact your Saab dealer for an inspection. Refer to "Cruise control" in chapter 7 for the deactivation procedure of the cruise control system. This indicator shows the position of the selector lever. ¢ Turn signal indicator lights These lights show the operation of the turn signal or lane change signal. If the indicator lights do not blink or blink rapidly, the turn signal bulb may be burned out. Replace the bulb as soon as possible. Refer to the "Replacing bulbs" section in chapter 11. NOTE If you move the cruise control lever or press the main switch button while turning the ignition switch "ON", the cruise control function is deactivated and the "CRUISE" indicator light flashes. To reactivate the cruise control function, turn the ignition switch back