2006 Saab 9-2X Owner's Manual - Page 185

Starting and operating 7-13 standstill on slippery road surfaces such as mud or snow. It will ensure greater traction. q 1 (First) This position is for driving up or down very steep grades, or driving through mud or sand, or on slippery surfaces. In this position, the transmission holds in the 1st gear. q Maximum speeds The following tables show the maximum speeds that are possible with each different gear. When shifting down a gear, it is important to confirm that the current vehicle speed is not in excess of the Maximum Allowable Speed of the gear which is about to be selected. mph (km/h) Non-turbo models 1 2 3 28 (45) 62 (100) 97 (156) Turbo models 28 (45) 65 (104) 104 (167) mission will remain in the current gear if the speed of the vehicle is in excess of the Maximum Allowable Speed for the gear to which the selector lever has been moved. position on an uphill grade by using the "D", "3", "2", or "1" position. Use the brake instead. The engine may, on rare occasions, knock when the vehicle rapidly accelerates or rapidly pulls away from a standstill. This phenomenon is not an indication of a problem in your vehicle. When shifting down a gear, ensure that the vehicle is not travelling at a speed exceeding the Maximum Allowable Speed for the gear which is about to be selected. Failure to observe this precaution can lead to engine over-revving and this in turn can result in engine damage. In addition, sudden application of engine brakes when the vehicle is travelling on a slippery surface can lead to wheel locking; as a consequence, control of the vehicle may be lost and the risk of an accident increased. q Driving tips — Always apply the foot or parking brake when the vehicle is stopped in the "D", "3", "2", "1" or "R" position. — Always set the parking brake when parking your vehicle. Do not hold the vehicle with only the transmission. — Do not keep the vehicle in a stationary ¢ Shift lock release If the selector lever does not move from the "P" position with the brake pedal depressed and the ignition switch in the "ON" position, perform the following steps: To override the shift lock: 1. Set the parking brake and stop the engine. 2. Take out the screwdriver from the tool bag. 3. Remove the cover by prying on the edge with the screwdriver. NOTE In order to prevent over-revving during deceleration of the vehicle, the trans- - CONTINUED -